The magnet doesn't make the lock move: Every lock will work differently, but it's typically friction that causes this problem. If a piece of your lock is supposed to move, be sure it can move easily. If it's attached too tightly, your magnet may not be able to move it.
Slide another bobby pin or paperclip around in the master lock in order to disengage the spring from the lock. A popping noise will be heard when the master lock spring disengages and the lock will pop open. Using a bobby pin or a paperclip is a quick way to pick a master lock without breaking it.
If the door has a knob or handle, push IN on the door firmly, then use the magnet to unlock the door. If the lock is in contact with the strike, it will not unlock with the magnet. The strike should be adjusted to allow the lock to swing freely. If the door has no handle, make one using tape.
With the help of rare earth magnets, opening a safe can take just seconds. At least that is what Terry Whin-Yates of Mr. ... He showed that using a rare earth magnet, one can exploit the nickel piece in this Sentry Electronic Safe to get it open without any damage.
Switch off your Android handset and wait for some time.
Now Press the '+' volume button and power button at the same time.
It will open your Android device in Recovery mode. ...
Next, when you get a list of options, tap on the 'Wipe Cache Partition To Clean Data'.
Because mag locks by design require a constant supply of electricity to remain locked, mag locks are fail-safe only — they do not function to keep the door locked from either side when the power is out.
With a magnetic lock, the door is always locked from both sides of the opening. ... Electric strikes provide security only for the exterior side of the door. Occupants can freely exit at any time from inside the building simply by turning the knob or handle, or by depressing the pad on the exit device.
Electrified Mortise locks
This function ensures that anyone inside can get out simply by turning the handle, but outsiders must use a key or electric control of the lock solenoid. ... In fail-safe mode, power must be applied to lock the lock, whereas in the fail-secure mode power must be applied to unlock the lock.
The positive and negative poles are reversed, the power supply is wrong, and the magnetic lock itself is bad.
Factory Address:Building S4A, South Third Lane, Qiuyuling Street, Zhangkeng Village, Hengli Town, Dongguan City, Guangdong Province Office Address:#601,floor 6 ,building 1,JINFANGHUA industrial zone, Bantian St. Longgang Dist. Shenzhen, PRC.
If you are interested in our products and want to know more details,please leave a message here,we will reply you as soon as we can.