Electrified Mortise locks
This function ensures that anyone inside can get out simply by turning the handle, but outsiders must use a key or electric control of the lock solenoid. ... In fail-safe mode, power must be applied to lock the lock, whereas in the fail-secure mode power must be applied to unlock the lock.
The positive and negative poles are reversed, the power supply is wrong, and the magnetic lock itself is bad.
A strong enough magnet can destroy just about any electrical device. Especially laptops, computers, cell phones, hard drives, flash drives, or almost any advanced device. They can even destroy an LED screen. ... The magnets don't damage electronics directly.
An electromagnetic lock, magnetic lock, or maglock is a locking device that consists of an electromagnet and an armature plate. There are two main types of electric locking devices. Locking devices can be either "fail-safe" or "fail secure". ... Direct pull electromagnetic locks are inherently fail-safe.
Electromagnetic Fire Door Holders
The magnet is wired to and powered by the fire alarm panel and is automatically switched off in case of fire, releasing the fire door and allowing it to close. The magnetic fire door retainers can also be manually released via a push button.
That is until the power is cut. Because mag locks by design require a constant supply of electricity to remain locked, mag locks are fail-safe only — they do not function to keep the door locked from either side when the power is out.
If the door has a knob or handle, push IN on the door firmly, then use the magnet to unlock the door. If the lock is in contact with the strike, it will not unlock with the magnet. The strike should be adjusted to allow the lock to swing freely. If the door has no handle, make one using tape.
To deactivate the magnetic security strip, all that need be done is to magnetize the strip along its length. This can be done by applying a sufficiently strong magnetic field along the length of the strip.
Be sure the lock is being powered by a DC source and that polarity is correct (RED to positive DC BLACK to negative DC). If the Magnalock is wired in reverse polarity, it won't be damaged, but it will not operate.
If the unit continues to appear dead, it must be electrically checked with an Ammeter. It must be powered with the correct input voltage and checked to see if it draws the specified current. If the unit meters correctly, then the magnet body is operating properly and the problem must lie in the mounting of the strike.
Factory Address:Building S4A, South Third Lane, Qiuyuling Street, Zhangkeng Village, Hengli Town, Dongguan City, Guangdong Province Office Address:#601,floor 6 ,building 1,JINFANGHUA industrial zone, Bantian St. Longgang Dist. Shenzhen, PRC.
If you are interested in our products and want to know more details,please leave a message here,we will reply you as soon as we can.