Check the input of the power, whether it's accord to the demand(12V,1A or above), if yes
Change the power/voltage for specializing version or Change the high-quality wire
and make sure the length is within 10m.
Check power connection/indication, if yes, Change the power/voltage for special use.
or Change the high-quality wire and make sure length is within 10m.
Check with the model of release button that's been used, whether it's a NO or NC type.
Electromagnetic locks consist of an armature and a coil assembly, which become magnetized when an electric current passes through them. This magnetic field secures the door and electronically controls when doors are locked and unlocked. Electromagnetic locks are fail-safe by design.
Because the mating area of the electromagnet and armature is relatively large, the force created by the magnetic flux is strong enough to keep the door locked even under stress. Typical single door electromagnetic locks are offered in both 600 lbs. (2669 N) and 1200 lbs.
An 0.015-inch aluminum sheet cut to fit the strike plate and fixed by an adhesive will go unnoticed and reduce the magnet locks holding force from 1200 pounds to approximately 300 pounds. Most men can put that much shoulder into jarring the device open.
Magnetic door locks use an electromagnetic force to stop doors from opening, so they are ideal for security. Maglocks, such as the Deadlock mag locks are made up of an electromagnet and an armature plate. The plate is attached to the door and the magnetic to the door frame.
Clean off any residue such as tape or grease from the back of the lock you wish to open and make certain it is dry. ...
Pull up the top of the lock as far as it will go. ...
Turn the wheel to the right or clockwise slowly. ...
Continue turning the wheel clockwise slowly until you feel another bump.
Connect the negative terminal from your REX button to the negative lead from your power supply. Then, connect the positive terminal from your REX button to the positive lead from your power supply. When you plug your power supply back in, the LED of the button should turn on.
Factory Address:Building S4A, South Third Lane, Qiuyuling Street, Zhangkeng Village, Hengli Town, Dongguan City, Guangdong Province Office Address:#601,floor 6 ,building 1,JINFANGHUA industrial zone, Bantian St. Longgang Dist. Shenzhen, PRC.
If you are interested in our products and want to know more details,please leave a message here,we will reply you as soon as we can.