This article mainly introduces the installation method of the magnetic lock on the surface of the outer door
Magnetic lock: a strong suction force can firmly hold the adsorption iron plate to achieve the effect of locking the door. As long as a small current electromagnetic lock will generate a huge magnetic force, the access control system that controls the power supply of the electromagnetic lock will turn off the power after identifying the correct person, and the electromagnetic lock can open the door after losing its suction. Because the electromagnetic lock has no complicated mechanical structure and the structure of the lock tongue, it is suitable for the access control of the escape door or the fire door. Its interior is protected by infused epoxy resin.
At present, the suction strength of the electromagnetic lock for door is expressed in LB (pounds), and the test method is static pressurization. The so-called static pressure means that the electromagnetic lock gradually increases the pulling force on the adsorption iron plate after the electromagnetic lock is energized. When the suction force of the 600lbs electromagnetic lock is exceeded, the adsorption iron plate is instantly pulled away. The data of this pulling force is the pulling force value of the electromagnetic lock. Moreover, the force between the 12V electromagnetic lock and the adsorption iron plate must be face-to-face and pressurized in a straight line, so that the suction force of the electromagnetic lock is the largest. The adsorption iron plate may be temporarily magnetized due to the magnetic induction of the electromagnet for a long time.
How to install electromagnetic door lock kit?
Surface installation method of external door
Step 1: First open the cover with a screwdriver, then hit the side plate with a hexagonal wrench, ready to install;
Step 2: Take out the installation cardboard, fold the cardboard along the dotted line, put the cardboard in the position where the lock needs to be installed, and then mark the place to be punched and punch the hole;
Step 3:
A. Following the fixing of the iron plate, insert the inner hexagon screw into the subsequent iron plate, place the rubber washer between two pieces of metal washer, and then set it on the inner hexagon screw. Insert the following iron plate into the three holes punched on the door, insert the mushroom head from the other side of the door at the same time, and use the hexagonal wrench to lock the following iron plate on the door;
B. To fix the side panel, fix the side panel to the previously punched door frame (fixed in the long hole of the side panel) with two half-round screws. Note: Do not lock the side plate, so that it can move back and forth to facilitate the correction of the position;
C. Correct the position of the side plate so that the position of the side plate and the follower iron plate is suitable, so that the main body of the lock can be in close contact with the follower iron plate;
D. After fixing the main body of the lock and the side plate and locking the dome head screws of the side plate, lock all the countersunk head screws, then remove the dome head screws, and drill holes in appropriate positions for wiring. Finally, lock the main body of the lock on the side plate with a hexagonal wrench;
Step 4: Wiring according to the instructions in the manual;
Step 5: Take the cover and insert the small aluminum cylinder into the screw hole of the lock body.
Author: Written by Ms.Juan from S4A INDUSTRIAL CO., LIMITED
Factory Address:Building S4A, South Third Lane, Qiuyuling Street, Zhangkeng Village, Hengli Town, Dongguan City, Guangdong Province Office Address:#601,floor 6 ,building 1,JINFANGHUA industrial zone, Bantian St. Longgang Dist. Shenzhen, PRC.
If you are interested in our products and want to know more details,please leave a message here,we will reply you as soon as we can.