There are several reasons why the electric mortise lock head cannot be lowered:
The operator sets the door to the normally open state in the access control software.
The door open button is stuck and stays pressed all the time.
The voltage is not enough, or there is no voltage (for example, the line is broken, or the power supply is broken, etc.).
The magnetic piece is too far away from the lock head or the door is not closed properly, the magnetic piece and the lock head are not vertically corresponding, but offset, and the lock head cannot sense it.
The electric lock has a delay, and the lock will not come down until the delay is over. The delay of the electric mortise lock can be set to 0-9 seconds, generally no delay is set, and the delay is 0 seconds
The electric lock is broken.
There are several reasons why the electric mortise lock cannot be locked:
The operator has set the door to normally closed state in the access control software.
The lock head may be stuck, for example: dust has entered the lock body, or the mechanical design process is defective and jammed. (This situation is relatively bad, but generally it will not happen. Note that the electric lock should not be installed on the
Author:Written by Ms.Rebecca Fu from S4A INDUSTRIAL CO.,LIMITED
Factory Address:Building S4A, South Third Lane, Qiuyuling Street, Zhangkeng Village, Hengli Town, Dongguan City, Guangdong Province Office Address:#601,floor 6 ,building 1,JINFANGHUA industrial zone, Bantian St. Longgang Dist. Shenzhen, PRC.
If you are interested in our products and want to know more details,please leave a message here,we will reply you as soon as we can.