What products should be equipped when the Emergency Exit Electronic Push Rod needs to be selected to achieve a remote linkage alarm?
The fire push rod alarm lock can achieve a linkage between remote monitoring and remote alarm. The products that need to be used mainly include a fire push rod alarm lock, linkage monitoring and control host, control power supply, and wire passer. In addition, wiring is required during installation.
Illustrate:
1. On-site 220V power supply control power supply. Control power output DC 9v power supply 510P and 520P push rod alarm lock (positive and negative wires of DC power supply cannot be reversed).
2. 510P and 520P push rod alarm edge feedback signal and connect the wire to the alarm control host (do not recognize the color or front and back).
3. After closing the alarm remotely through the corresponding button of the host, it must be reset before the push rod alarm lock can be restored to the set alarm state.
4. The effect of installation completion: After pushing any push rod alarm lock on site, an alarm is issued and a feedback signal is sent to the alarm control host at the same time. The corresponding indicator light of the host turns from green to red and an alarm is issued.
The alarm control host will remotely turn off the alarm on the button (the control button of the alarm host must be reset to restore the set alarm state), and the key can be used to turn off the alarm on-site.
Stainless Emergency Exit Panic Push Bar Lock
Product Features:
• For emergency use, push the lever to open the door and give an alarm (under the premise of setting the alarm).
• With normally open and normally closed passive feedback signals, it supports remote setting or canceling of alarms.
• Cancel or set alarm by key. In the setting alarm state, the push rod sends out an alarm above 100 decibels.
• In the state of canceling the alarm, the push rod will not make an alarm sound.
• With passive switch signal.
• Alarm powered by 9V battery or 9V power supply.
•Linkage function: remote host linkage, delay alarm lock linkage.
Related Configuration Products
push rod alarm lock | delay module | electromagnetic lock | emergency button | access controller | control power supply
12V, 9V control power supply
Product parameters: XF12-3AV
Scope of application:
Supporting the use of access control, linkage push rod alarm power supply, electromagnetic door stop power supply release
Features:
AC input: standard 220VAC, 50HZ;
DC output: Standard 12VDC
Direct control electric lock:
It can reduce the load of the access control controller, save engineering wiring, and reduce hidden troubles.
With NC/NO output, it can control various types of electric locks.
A delay control circuit is set up, and the unlocking time can be 0-10 seconds.
Set the door open button input, can directly open the electric lock, automatic protection function.
Author: Written by Anna Zhang from S4A INDUSTRIAL CO., LIMITED
Factory Address:Building S4A, South Third Lane, Qiuyuling Street, Zhangkeng Village, Hengli Town, Dongguan City, Guangdong Province Office Address:#601,floor 6 ,building 1,JINFANGHUA industrial zone, Bantian St. Longgang Dist. Shenzhen, PRC.
If you are interested in our products and want to know more details,please leave a message here,we will reply you as soon as we can.